This pad heater allows you to heat your tank before you drive off in the morning by plugging it into your house mains (120V) as you would a block heater. At 1000-watts, this heater will only need to be plugged in for less than 30 minutes to heat most common tank sizes (10-50 gallons), and will ensure you have thin, flowing SVO/WVO on even the coldest mornings. This heater can be also be used on B100 tanks in cold climates where wax formations may otherwise cause supply problems.

Another possible use for this heater is to adhere it to the bottom of a drum and use for heating your SVO/WVO prior to filtration/processing.

Specs: 120 volt, 1000-Watt, 8.3 amps, 6" x 10.75". Self-adhesive pad heater with special 3M adhesive backing, designed to adhere to all bare metal surfaces. Heater is wired with standard 3-pin 120v plug. Not for use on plastic tanks!

Installation kit also comes with instruction sheet, nylon ties (4), 1 tube of high temp silicon to seal heater edges, and a plastic spatula for installation.